A little Green Lantern bling for Comic-Con - It arrived! on Shapeways Discussions about 3D Printing

Home » Community » It arrived! » A little Green Lantern bling for Comic-Con

A little Green Lantern bling for Comic-Con [message #31785] Fri, 29 July 2011 07:59 UTC

3DG33K
Messages: 1
Registered: July 2011
Go to my shop

Junior Member

My WSF rings arrived!!
index.php?t=getfile&id=10228&private=0

Prepping the rings for painting:
index.php?t=getfile&id=10229&private=0

Primed and ready:
index.php?t=getfile&id=10230&private=0

After some Testor's Metallic Emerald Laquer:
index.php?t=getfile&id=10231&private=0

The ring is a replica of the artist's Ivan Reis design that appeared in Green Lantern: "Blackest Night".
I loved the design (better than just a circle with two attached lines this was a 3D carving of the logo really
resembling the lantern). I made 10 of these and gave them out at Comic-Con and kept one.

Attachment: WSF_raw_rings.JPG
(Size: 107.14KB, Downloaded 494 time(s))
Attachment: WSF_mounted_rings.JPG
(Size: 200.42KB, Downloaded 486 time(s))
Attachment: WSF_primed_rings.JPG
(Size: 142.50KB, Downloaded 488 time(s))
Attachment: WSF_finished_ring.JPG
(Size: 209.54KB, Downloaded 493 time(s))