Home » Community » General Discussion » 28mm Miniatures
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
28mm Miniatures [message #25974] Tue, 12 April 2011 16:47 UTC Go to next message
avatar JosephUrban  is currently offline JosephUrban
Messages: 1
Registered: April 2011
Go to all my models
Junior Member
Looking to get miniatures printed out using zbrush and wondering if it is possible - and if so are there any links to the results?


Joseph

[Updated on: Tue, 12 April 2011 16:49 UTC]

Re: 28mm Miniatures [message #26028 is a reply to message #25974 ] Wed, 13 April 2011 22:49 UTC Go to previous messageGo to next message
avatar kwakaine  is currently offline kwakaine
Messages: 1
Registered: December 2009
Go to all my models
Junior Member
The detail level is not good enough for 28mm mini's atm, hopefully we'll get wax printing or similar sometime soon and then it will be good enough.

Re: 28mm Miniatures [message #27234 is a reply to message #25974 ] Tue, 10 May 2011 12:03 UTC Go to previous message
avatar Nane  is currently offline Nane
Messages: 171
Registered: August 2010
Go to all my models
Senior Member
Frosted Ultra Detail was just added http://www.shapeways.com/materials/frosted_detail and is perfect for printing pro quality castable miniatures, something I have been waiting for with baited breath this whole time.

You will need to cast the master miniatures using a RTV mold, great success has been found with the Niceme Green RTV Mold for casting pewter masters miniatures to make squash (production) molds. Mike at Iron Wind Metals got a bunch of these for me and is capable of casting them if you need that kind of service.

 
   
Previous Topic:Copyright?
Next Topic:Yippie! I ordered some of the new material