Home » Support » 3D Printing » Not printable
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Not printable [message #22219] Thu, 06 January 2011 12:39 UTC Go to next message
avatar teocomi is currently offline teocomi
Messages: 2
Registered: December 2010
Go to all my models
Junior Member
Hello, my design was printable untill some weeks ago, but it isn't any more.. Why??

http://www.shapeways.com/model/187343/5core_micro_case.html

Thanks!
Report message to a moderator
Re: Not printable [message #22226 is a reply to message #22219 ] Thu, 06 January 2011 14:08 UTC Go to previous messageGo to next message
avatar Youknowwho4eva is currently offline Youknowwho4eva
Messages: 4063
Registered: September 2008
Go to my shop
Senior Member
I work here
Because of the depth of .2 I believe. Try rotating your model so that one end is higher than the other so that it's depth will increase.

The Mad Moder
michael@shapeways.com
Report message to a moderator
Re: Not printable [message #22321 is a reply to message #22226 ] Sat, 08 January 2011 09:52 UTC Go to previous message
avatar teocomi is currently offline teocomi
Messages: 2
Registered: December 2010
Go to all my models
Junior Member
Thanks, I'll give a try!
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Problems with Detail
Next Topic:Problem Update: Dimensions, but no volume