| big WSF printer [message #20783] Sat, 20 November 2010 19:22 UTC |
 |
|
Hi,
I just received prints in WSF. they are from models i had previously had printed in WSF. They were sized to fit in the limits of that printer an I know there was only one way it would fit in it. Though the new prints i got are not printed in the same orientation and the quality of the print is not as good as the first print i had. So I conclude that they were printed on the new big WSF printer, which, if i understood well does have a 0,5 instead of 0,2 mm minimum detail.
am I right?
someone else had that issue?
and to shapeways team: can you explain
thanks
|
|
|
| Re: big WSF printer [message #20785 is a reply to message #20783 ] Sat, 20 November 2010 23:15 UTC |
 |
|
Hey Flat-twelve
Please send an email to service (at ) shapeways.com and they will be able to answer your questions.
cheers
Duann Scott
|
|
|
Search
