Our Gift to You: 20% off your own designs in Strong & Flexible Plastic through Dec 23, with promo code MY2014 · details
Home » Support » 3D Design » Quick question regarding Earring Contest...
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Quick question regarding Earring Contest... [message #15369] Wed, 28 July 2010 16:56 UTC Go to next message
avatar Drawn-SteelHero  is currently offline Drawn-SteelHero
Messages: 456
Registered: June 2010
Go to my shop
Senior Member
The design sheet for the earring design contest shows that the minimum line thickness allowed is 2mm. Does this mean that you can't have any structural part thinner than 2mm (which makes sense), or does it refer to detailing as well?
The design I'm putting together at the moment is basically solid, but has smaller raised detail (on the image, mid grey with smallish black details). I would assume this should be fine, but I just wanted to check.

Andy
Re: Quick question regarding Earring Contest... [message #15390 is a reply to message #15369 ] Thu, 29 July 2010 00:25 UTC Go to previous messageGo to next message
avatar bitstoatoms  is currently offline bitstoatoms
Messages: 407
Registered: March 2009
Go to my shop
Senior Member
I work here
Hi Andy

Small raised detail should be fine....



Duann Scott

Re: Quick question regarding Earring Contest... [message #17315 is a reply to message #15390 ] Mon, 06 September 2010 07:32 UTC Go to previous message
avatar virtox  is currently offline virtox
Messages: 1171
Registered: August 2008
Go to my shop
Shapie Expert
moderator
No Message Body

[Updated on: Mon, 06 September 2010 07:32 UTC]


- Artist / Engineer / Designer / Shopowner / Volunteer / Moderator -

 
   
Previous Topic:Noob Question
Next Topic:Jewelry Design and Prongs

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.