Home » Support » Bug Reporting » MATERIALS BUG
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
MATERIALS BUG [message #13741] Wed, 16 June 2010 14:28 UTC
avatar lensman  is currently offline lensman
Messages: 1462
Registered: December 2009
Go to my shop
Senior Member
I uploaded a new model yesterday and in looking at it today I see that there is a problem with the materials it is availalable in. I left all at the default and yet it is only available in the three DETAIL materials. It is also, co-incidentally, NOT available in these three materials!

I would suggest all to take a look at recently added models.

I have notified Shapeways.

My model here: http://www.shapeways.com/model/129475/2010_world_cup_pendant __5cm_.html

** EDITED -- This was due to my error. The thickness of the pendant was 2mm and I had to increase to 3mm to make printing in all materials availalable **

[Updated on: Thu, 17 June 2010 03:00 UTC]


Glenn ------ My Website Third Dimension Jewellery

 
   
Previous Topic:theme page fixes
Next Topic:Combinatory Manufacturing questions