Home » Community » Introductions » Hey there! (first model)
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Hey there! (first model) [message #13676] Mon, 14 June 2010 20:06 UTC Go to next message
avatar wouzy  is currently offline wouzy
Messages: 2
Registered: June 2010
Go to all my models
Junior Member
Hey there!
I'm new.. just saying hi and showing my first design..

http://www.shapeways.com/model/129005/heartcompletetest.html

I'ts supposed to be 2 tail hanging ear spiral piercings fused together to make a heart... it'll be made from stainless steel. it's to be a gift for my girlfriend Smile.

I'd love it if you guys could check it over, especially since im not sure i merged the 2 parts properly in solidworks assembly. Also whether or not it may be too small, or that the surface might turn out very coarse or any other comments..

Would hate to waste €25 Razz

Much thanks in advance, and see you around!

Re: Hey there! (first model) [message #13677 is a reply to message #13676 ] Mon, 14 June 2010 20:26 UTC Go to previous messageGo to next message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5315
Registered: September 2008
Go to my shop
Senior Member
I work here
as long as it's 3mm thick there shouldn't be a problem.


Your friendly neighborhood Moderman
michael@shapeways.com
Re: Hey there! (first model) [message #13678 is a reply to message #13677 ] Mon, 14 June 2010 20:53 UTC Go to previous message
avatar wouzy  is currently offline wouzy
Messages: 2
Registered: June 2010
Go to all my models
Junior Member
well.. it is more then 3mm in the thickest parts.. but it is tapered so the endings will not be..

 
   
Previous Topic:Hello everyone!
Next Topic:Hey all!

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.