Home » Support » 3D Design » Looking for 3D Scanner
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Looking for 3D Scanner [message #13420] Sun, 06 June 2010 16:44 UTC Go to next message
avatar 3DGirl  is currently offline 3DGirl
Messages: 1
Registered: June 2010
Go to all my models
Junior Member
Hi There,

I am looking for a 3D Scanner for animation and CG. Anyone has any advice in what I should be looking for? Product recommendations?

Thanks in advance,

3DGirl
Re: Looking for 3D Scanner [message #13841 is a reply to message #13420 ] Sun, 20 June 2010 22:57 UTC Go to previous messageGo to next message
avatar rawkstar320  is currently offline rawkstar320
Messages: 417
Registered: January 2009
Go to my shop
Senior Member
How detailed? There is some software out there called David 3D Scanner that does basic scans. Otherwise, I think there was a guy on the site that had access to a scanner.

In September, I will have access to a scanner (for free + my time[cheap] ) so let me know if I can help you out.

Jake
JakeDrews.Com

[Updated on: Sun, 20 June 2010 22:58 UTC]


Aut Viam Inveniam Aut Faciam
Check out http://JakeDrews.Com and http://WondrousWidgets.Com for more designs by Jake!
Re: Looking for 3D Scanner [message #14191 is a reply to message #13420 ] Thu, 01 July 2010 13:32 UTC Go to previous messageGo to next message
avatar bartv  is currently offline bartv
Messages: 1668
Registered: December 2007
Go to my shop
Shapie Expert
Here's a review I did with the David scanner. It's relatively inexpensive, but you will have to put in some serious time to get nice clean and detailed results.

http://www.shapeways.com/blog/archives/248-DAVID-3D-Scanner- Starter-Kit-Review.html

Bart


Community Manager Europe | Shapeways
Re: Looking for 3D Scanner [message #14222 is a reply to message #13420 ] Thu, 01 July 2010 18:33 UTC Go to previous message
avatar scubasonar  is currently offline scubasonar
Messages: 1
Registered: May 2010
Go to my shop
Junior Member
I have a NextEngine(http://www.nextengine.com/). It works great for some stuff, not great for other stuff. Thin features are tricky to capture and holes in things cause problems too. Objects with lots of general roundness to them made out of clay scan great. Here's a fabric dog toy(well, my grandparents let their dog play with it) that I scanned with it and shrunk down: http://www.shapeways.com/model/122439/taco_dog.html

[Updated on: Thu, 01 July 2010 18:34 UTC]


 
   
Previous Topic:Calculation is off?
Next Topic:Ran it through Cad Span, manifold error still

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.