Inverted Normal on a laryngoscope

Discussion in 'Design and Modeling' started by 20989_deleted, Apr 24, 2009.

  1. 20989_deleted
    20989_deleted Member
    Dear all,

    I'm quite a newbie to all of this, but I can't seem to figure out what normal problem I'm having with this design.

    It was created with Sketchup 7, and I exported it both as Collada and STL, but it does not work.

    I severed the blade (upper part) from the handle. The blade works but the handle doesn't.
    So I suppose it it probably the handle.

    I tried to recreate it several times in several different ways, but that doesn't help me.


    Can anybody help me please?

    Thank you and kind regards

    Teus
     

    Attached Files:

  2. ArMOO
    ArMOO Member
    Hi t-muts,

    This stl should be printable, but you've to resize it.
    It became bigger its scaled 1,he model is ok you had some problems at the hartshape itself and where the har
    tshape is attached to the tube.
    A boolean operation or a fillet might solve the problem also.

    Greetings AO
     

    Attached Files:

  3. 20989_deleted
    20989_deleted Member
    Thanks AO,

    Now I know what to look for.
    I just couldn't find it.

    Thanks again.

    T-Muts