I have mentioned the following issue(s) a few times in mails and on the forum and so did others but there was never a really clear answer on how those requests will (or won't) be handled.
To sum up what I'm talking about:
There are a few people (including me of course) who want and/or need to get higher quality prints than currently possible. What I'm talking about is the HQ mode of your Eden machine and definable model orientation.
This probably won't be necessary too often (especially the latter case) but there's definately quite a few situations where it is because the difference is absolutely visible and often enough even crucial.
There's of course higher printing times in HQ mode and sometimes also more supportmaterial has to be used but I would be absolutely willing to compesate that by paying a higher price for a model where I can choose such options and I think others would behave the same way.
Atomating the calculation of such a new price would also be possible yet it's apparently a bit more complex than the current method.
That much about this topic for now, it would be very much appreciated if you'd give a statement whether and in which way this is being considered for the future.
One more thing out of pure curiosity:
Is there any way for you to print a material which is easier to alter afterwards (detailing, probably adding or removing parts, etc.)? I think of something in the direction of wax because that would save quite a lot of money for wastemolds.
Yours,
Fabian