Seeing Stars

Discussion in 'Feature this!' started by 374051_deleted, Oct 3, 2013.

  1. So this is my first ring that's been printed I feel confident in sharing.

    [​IMG]

    [​IMG]

    Any suggestions? What do you guys think? =D

    There is a little thing I'm confused/concerned about though. On the model there's a gap in the ring but when it was printed it ended up fully closed why is that? Were my ends just too close together or was it a structural integrity thing?

    Seeing Stars Ring Size 7 (Other Sizes Available in Description)
     
  2. FabMeJewelry
    FabMeJewelry Member
    Nice ring design ! :eek:

    It looks like the gap should be wide enough but i can't measure, clearance should be bigger than 0,3 mm.
    Maybe somebody made the mistake to locate the sprue at the location of the gap ?
     
  3. SavIsSavvy
    SavIsSavvy Member
    This is great! You're definitely a rising Shapeways *star* - thanks for sharing! Will feature soon :)