This is a doillie model with a lot of negative spaces like holes and I would like to know if I am able to get all the details.
It was about 20x8 cm and size of holes are more than 1mm. I would like print in white plastic or ceramic.
20 centimeters?? That's going to be very expensive. http://stonysmith.com/wired/VolumeEstimator.asp?L=200&W= 200&H=80&T=0&S=1 for the number of holes you have, the price will be around 1/3 of that cost, but still pricey. If you were wanting only 8mm thick, that'd be much more reasonable: (again, about a third of this cost because of the holes) http://stonysmith.com/wired/VolumeEstimator.asp?L=200&W= 200&H=8&T=0&S=1 For everything except ceramic, 1mm holes are plenty big enough.. for ceramic they need to be 3mm.