Modeler needed for simple pendant model to be created

Discussion in '3D Design Requests' started by Jahotur, Nov 10, 2012.

  1. Jahotur
    Jahotur Member
    Hello. I am looking to recreate this pendant.I would like to print it in stainless or a similar heavy metal. If the lines of the squared shapes of the tile can be etched in I can enamel the "stone" faces. It wold measure 3.5cm long. Flat top would be 1.5cm. Flat bottom 1cm. Slanted sides are also 3.5. Any help would be appreciated. If you have Silence of the Lambs on DvD you can get a good glimpse of it ;)
     

    Attached Files:

    Last edited: Nov 11, 2012
  2. CADNinja
    CADNinja Well-Known Member
    PM Sent