Centaur figure

Discussion in 'My Work In Progress' started by MichaelMilano, Oct 6, 2012.

  1. MichaelMilano
    MichaelMilano Member
    ]Hello, It has been a while since being active on Shapeways, and can't believe the level of prints from just a few years ago. I have recently been helping people with their models and wanted to start uploading some of my own again. Here is a Centaur, 60mm in height. If anyone has any suggestions, or would like it at a specific height let me know. There is also a turntable on the Shapeways page. Hope you like it!

    Best, mike

    shapeways.jpg

    https://www.shapeways.com/model/727603/centaur-60mm.html
     
  2. kiorodesign
    kiorodesign Well-Known Member
    I'm really impressed by your talent as a sculptor ...wonderful.
     
  3. MichaelMilano
    MichaelMilano Member
    Thanks Kiorodesign, hopefully people will enjoy it!
     
  4. lensman
    lensman Well-Known Member
    Yes, wonderful job. ZBrush, I assume? I'm always surprised I don't see more people from the ZBrush forums here on Shapeways.

    Glenn
     
  5. MichaelMilano
    MichaelMilano Member
    Thanks Glenn!

    Yes it's zbrush work, I have also wondered why there isnt more here on Shapeways. Probably just depends on the figurine market here, I am not sure.
     
  6. That is really amazing. What kind of material are you going to use on that? I love it.
    ~Emily~