Hey there guys! Just finished up a new design since I haven't done anything on here in a while. Please check it out if you have the time. https://www.shapeways.com/model/713911/e889274b90d8227edaf11a 3c7677f7c2
oh think I made an error by not reading the "READ THIS FIRST" post. Sorry. So don't feature this, because it hasn't been produced yet (not that I foresee any problems), but check it out anyway
It seems that your design has finer details than 0.3 mm. AFIAIK it can not be printed. Or did the printing rules change?
Hmm well the pyramids are 0.4 mm and they're the smallest things on there. And I've had something cast with small converging points before, and that worked out fine. Thank you very much for checking out my work