The third public evolution of the Animaris Geneticus Parvus. #7 has evolved legs, with pointy feet instead of flat. Featuring a fully working Theo Jansen mechanism as used in his work "the Rhinoceros".
Also see our new Propeller Propulsion add-on, to have your Strandbeest walk autonomously!

The mechanism is printed assembled, and will work without further assembly right after birth from the printer.

A few tips to consider:

- After birth there might be a little powder left in some joints, or it might not go supersmooth. This will fix itself after the animal has a little bit of practice!

- Some surfaces work better than others. The legs require a little friction, and a flat surface. So for example: A rough table or floor, thin flat carpeting, or a thin rubber sheet. It will slip on a too smooth surface.

- The best way to push it is by its nameplate. Do not push down, but forward.

- The beest is light, but quite strong. It can actually be dropped without breaking. It is not a "toy" however, and not suitable for children. The 3D printer material is easy to stain so clean hands are advised.

Many photographers lose there lenscap, especially me.
So it was time to solve this problem. With this cap holder you just click your lenscap in and are ready to go.

This holder is suitable for every 58mm lenscap I can design other holders for different diameters
If you can't find your size in my shop, please order the customizable version.
That version has a shapeways personalize option where you can request your diameter