My case for Raspberry Pi computer. To be assembled with the "LED lightguide" model nr. 486757 (http://shpws.me/6yFP). This is the case everyone is talking about! ;) Features: snap-fit fixing system for the board, easy to mount/unmount; snap-fit closing system, no screw required; bottom holes for blocking the computer by screws (sliding mount); led lightguides (not included in this model, available here: http://shpws.me/6yFP ); pre-shaped hole for GPIO access, just cut it out to open. In this page you can find a gallery of shots working cases by enthusiast users! http://marcoalici.wordpress.com/raspberry-pi-case-gallery/

The design is based on the classic Celtic-style knot symbol for the World Tree from Norse mythology, Yggdrasil.

Inside the leaves you can see a small sphere of blue. If you look reaaally carefully, you could notice that the continents in the blue ball are in the shape of Pangea and not our current distribution.

Case compatible with the Raspberry Pi computer. GPIO port access from the side of the case. Optionnal : led lightguides for design case V2. http://www.shapeways.com/model/576641/raspberry-pi-led-lightguides-for-design-case-v2.html More information on : http://freakyshape.com/portfolio/raspberry-pi-design-case-v2/

Standard case for the Raspberry Pi computer. This case was successfully test with a production Pi board. I add an other clip and increase the thickness of all of them. So, on my pictures there are only 3 clips (for the closure system), but now there are 4 clips. The power button standard works with this case (this is optional). For more informations : http://freakyshape.com/

Both top and bottom parts are included in this model. Loads more info can be found on my website here; http://fusionweld.squarespace.com/blog/2012/3/8/raspberry-pi-custard.html. Spray it up yellow if you dare!