Activity

shauncs The total length of it is about 5CM (50MM). The port that connects to the wrist is about 6MM. I used some floor polish to thicken it up a bit as they get a little loose and wiggly over time.

shauncs @Zcat6 The peg here is sized for most Transformers Combiner Wars. The peg itself may fit the 6mm length, but the 3mm diameter you would need to sand it down towards the end in order to work.

shauncs @116wernerThat is correct! They come with 5mm pegs. I made these so in the event you have something that needs a reverse port you can.... The 5mm pegs you might find you still want to paint and seal. As I did and mine are relatively tight. Also because they are printed you might want to also look at doing some Future floor polish to the fingers as after a while the joints get a bit loose.

shauncs @cvapolo ah! The last release / print I did everything worked out pretty nicely. I want to leave this in Beta until someone else prints this and has success working with it. The only thing I want to change really here is make the gun/sword port open all the way down so Menasor's sword fits better. I will post more details regarding assembling these soon. I do recommend once printed to do a base coat primer and then sprayed with the final color of choice. The finger joints are also only held by a double ball joint so if they are not tight enough I do recommend using Future Floor Polish to finish. Mine happened to be good enough with just a all in one primer and spray paint. I did at least 3 coats to make sure the small holes from the 3D printer smooth out. See the link above: http://bruticus.net/2015/04/combiner-wars-3d-printed-hands/

shauncs @cvapolo not sure I understand what you mean by this?