Activity

QUEST_FPV @snap170 Sorry this was designed for a Phantom 1 / 2 controller.

QUEST_FPV @mountainman1 Hello! This is a good question. The part that keeps the mount secure is a "tooth ridge" that will snap into the side of the radio antenna mount preventing it from moving around. -Matt

QUEST_FPV @mediapioneersuk Hello! the Velcro strip can support a lipo battery for an fpv monitor or video receiver. Also this design has the advantage of a tilting monitor mount for your preferred viewing angle.

QUEST_FPV Hello! @regoczyzoli Shapeways does not produce the GoPro knob (screw) and monitor mounting screw. The monitor mount was designed so that easily available screws could be used with this item.

QUEST_FPV @RKnudsen Pmed, All the details you can give me the better.

QUEST_FPV @Davidleefiles The slim mount was designed so that it would fit easier into the case I had for my phantom. The other two have an extended horizontal battery bracket that will allow you to mount a power option easier. The difference between those two are the mounting holes. The FPV RX and Battery mount has built in "washer" mounts so the bracket doesn't sit flush against the monitor. The center mount bracket does not have these. I'll will post a image of the wiring example soon.

QUEST_FPV @Txfirecop To relieve the pressure of the plate on this cable you can take the extra landing skid foam pieces that come standard with the Phantom 2 and place them on the back of the plate in between the clip and the back of your gimbal so that it gives you some buffer room.