by
TheoJansen
The third public evolution of the Animaris Geneticus Parvus. #7 has evolved legs, with pointy feet instead of flat. Featuring a fully working Theo Jansen mechanism as used in his work "the Rhinoceros".
Also see our new Propeller Propulsion add-on, to have your Strandbeest walk autonomously!
The mechanism is printed assembled, and will work without further assembly right after birth from the printer.
A few tips to consider:
- After birth there might be a little powder left in some joints, or it might not go supersmooth. This will fix itself after the animal has a little bit of practice!
- Some surfaces work better than others. The legs require a little friction, and a flat surface. So for example: A rough table or floor, thin flat carpeting, or a thin rubber sheet. It will slip on a too smooth surface.
- The best way to push it is by its nameplate. Do not push down, but forward.
- The beest is light, but quite strong. It can actually be dropped without breaking. It is not a "toy" however, and not suitable for children. The 3D printer material is easy to stain so clean hands are advised.
Also see our new Propeller Propulsion add-on, to have your Strandbeest walk autonomously!
The mechanism is printed assembled, and will work without further assembly right after birth from the printer.
A few tips to consider:
- After birth there might be a little powder left in some joints, or it might not go supersmooth. This will fix itself after the animal has a little bit of practice!
- Some surfaces work better than others. The legs require a little friction, and a flat surface. So for example: A rough table or floor, thin flat carpeting, or a thin rubber sheet. It will slip on a too smooth surface.
- The best way to push it is by its nameplate. Do not push down, but forward.
- The beest is light, but quite strong. It can actually be dropped without breaking. It is not a "toy" however, and not suitable for children. The 3D printer material is easy to stain so clean hands are advised.
by
TheoJansen
[Note: The seperate propeller does not fit the Ondula version! We are working on a propeller for the Ondula]
Theo Jansen’s 3D printed Strandbeest continues to evolve with an even more elaborate walking mechanism and a centipede-like walking motion. The latest evolution called 'Animaris Geneticus Ondularis' walks on twenty separate legs that move in a wave sequence. This new configuration results in a fluent walking motion, different from its twelve legged predecessors. It incorporates 122 moving parts, showcasing the complexity of mechanisms possible with 3D printed fabrication. It is also slightly larger than its predecessors. The operating principle of 'Animaris Geneticus Ondularis' is based on one of Theo Jansen's original beach walkers, the 'Animaris Ondula'.
Currently there is no propellor available for this version, it is being worked on though!
In the movie we used a piece of cardboard for walking on. Anything will do as long as it's a little rough for some friction!
Theo Jansen’s 3D printed Strandbeest continues to evolve with an even more elaborate walking mechanism and a centipede-like walking motion. The latest evolution called 'Animaris Geneticus Ondularis' walks on twenty separate legs that move in a wave sequence. This new configuration results in a fluent walking motion, different from its twelve legged predecessors. It incorporates 122 moving parts, showcasing the complexity of mechanisms possible with 3D printed fabrication. It is also slightly larger than its predecessors. The operating principle of 'Animaris Geneticus Ondularis' is based on one of Theo Jansen's original beach walkers, the 'Animaris Ondula'.
Currently there is no propellor available for this version, it is being worked on though!
In the movie we used a piece of cardboard for walking on. Anything will do as long as it's a little rough for some friction!
