mangamike

by fakebusker83
Version 2.0

This mace comes in two parts which you have to order separately from Shapeways. This is part B, consisting of the blades and attack spike. Printing in Transparent Detail or Frosted Ultra Detail is recommended.

Link to Megamace Part A.
Link to MegaFlail Part A.
 
(3)  
  •  
From: $6.50
 
by fakebusker83
Version 2.0

This mace comes in two parts which you have to order separately from Shapeways. This is part A, consisting of the handle pieces and connector. Printing in Strong Flexible is recommended.
Link to Part B.
 
(3)  
  •  
From: $11.75
 
by fakebusker83
Version 1.5

Edit: Added spare fingers. Just in case!
A variant of the hands done for the Masterpiece Seeker figure, but this version has its wrist joint replaced with a ridged peg. The wrist peg is 5mm in diameter and peg section is 7mm long.
 
(2)  
  •  
From: $11.00
 
by WillLaPuerta
Know someone who's a 20? Keep a little (1.5 cm by 1 cm) photo of them inside this 20 sided die necklace. Comes in two parts. Pass your chord through the hole in the top half, through the loop inside the bottom half, and back out through the hole again. The loop is attached to a platform where you can glue picture.
 
(3)  
  •  
From: $17.46
 
by 7777773
Higher resolution version of the firebug model. Shapeways can't print this, but you can make one for yourself on any home printer. Here's the file: http://www.thingiverse.com/thing:11683 - now why don't you get yourself a printer and start making things?
 
(1)  
  •  
Not For Sale