[Note: This propeller propulsion add-on does not include a 3D printed Strandbeest, which should be bought seperately! This propeller does not fit the Ondula version!]

Theo Jansen’s 3D printed Strandbeest continues to evolve with the addition of a Propeller Propulsion system! The 3D printed Strandbeests can now walk autonomously, powered by the wind, just like Theo's full-scale Strandbeests. The new propeller add-on gives new and existing owners of these kinetic sculptures a new way to set them in motion!

The propeller addition is available as a separate kit, which can be mounted on the 3D printed Strandbeests. The propeller is compatible with the various evolutions of the Strandbeest, so existing owners of the “AGP” 5 and 7 model Strandbeests can use it as well. Consisting of 5 main parts, it can be mounted on the Strandbeest body in a few simple steps.
Also see our videos of the Strandbeest Propulsion in action, and the video with mounting instructions.

The 3D printed Strandbeest is sold separately.

A few tips to consider:

- Please look at our instruction video on mounting the Propeller Propulsion add-on, here.

- After mounting the Propeller Propulsion add-on it is best left mounted. Frequent dis-assembly can wear down the material which can result in play on the mechanism.

Nuke Lamp it's is a unique table lamp, its complex surfaces were created using real fluid dynamics simulations.
IMPORTANT:
The lamp consists of 2 parts, then you will receive 2 packages.... (open more info)...
one containing the 3D printed  piece from Shapeways, and a Kit containing the bulb and stand from Veneridesign, then please contact me info@veneridesign.com  for shipping address.
Thank you.

The first public evolution of the Animaris Geneticus Parvus, #5. Featuring a fully working Theo Jansen mechanism as used in his work "the Rhinoceros". The mechanism is printed assembled, and will work without further assembly right after birth from the printer.
Also see our new Propeller Propulsion add-on, to have your Strandbeest walk autonomously!

A few tips to consider:

- After birth there might be a little powder left in some joints, or it might not go supersmooth. This will fix itself after the animal has a little bit of practice!

- Some surfaces work better than others. The legs require a little friction, and a flat surface. So for example: A rough table or floor, thin flat carpeting, or a thin rubber sheet. 

- The best way to push it is by its nameplate. Do not push down, but forward

for iphone 4/4s. The hollowed case in combination with the contract color of the iphone itself gives a vivid animal figure. The case is stylish and in the same time heat eliminated.