Leander Duesterloh

Leander

3D modeler, Designer

I am 26 years old. I study aerospace at Braunschweig university in Germany.
 CAD is my biggest non sportive hobby. I love this site.


43
Followers
0
Following
Leander's
Leander commented on V8 ENGINE RING by bryson79
2 days ago
V8 ENGINE RING
Leander Very good design!
Leander commented on Cup of Tea Pendant (steel) by CorellaStudios
25 days ago
Cup of Tea Pendant (steel)
Leander This is brilliant.
Leander commented on Bike Engine Ring (Part 1/2): 18.5 mm by Leander
April 4, 2016
Bike Engine Ring (Part 1/2): 18.5 mm
Leander @Soludus Well, thank you!
Leander commented on Full Turbocharger Cufflinks by Leander
May 22, 2015
Full Turbocharger Cufflinks
Leander @aimeemoyer Thank you very much for your comment.
Leander commented on V8 Crank Shaft Keychain by Leander
February 14, 2015
V8 Crank Shaft Keychain
Leander @Shaggamathula I just researched again concerning my second last line. I found that flatplane crankshafts can have smaller balance weights then crossplane cranks. I don't know about a comparision to inline engines, but my second last line in the first post might be wrong. In any way, as far as V8 is concerned, flatplane crankshafts exist in sports cars. Ferrari has some engines with that type. I cannot find the picture any more, that I used as base for the model. However I did not try to create a specific certain model of a crankshaft with this part.
Leander @Shaggamathula Thank you for your words! It is good to hear that you like it. As far as the engine is concerned, it could also be an inline 4 engine. However on a V engine, there are always two piston rods on one hub, next to each other so the cylinders aren't exactly opposite but slightly offset. So this can also be a V8. I think often times on inline engines, the balance weights or "cheeks" will be smaller or thinner, because one hub has only one piston. In any way thanks a lot.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.