Working centrifugal compressor.

Designed to fit standard Mabuchi 130 motors.

Printed and tested.

Upon receiving the item, you'll need to use a 1.8mm drill bit to drill out the center hole. This is due to limitation of the printing process that may not allow the shaft of the motor to be inserted.

The filigree design over the skull symbolizes ever growing renewal over the ghost of the past. This is the original design as featured on Kickstarter. It became their #1 most funded sculpture project of all time. Large is approximately life-size. See pic of all 3 sizes together for comparison.

The Fire Gauntlet is an articulated hard-shelled glove, 3D printed all at once, fully assembled. The model is based on a 3D scan of my hand, with a 1.5mm clearance between the scanned surface and the printed model to allow for a Nomex cloth lining. Ideally the final design would be in stainless steel, but there are many challenges to making that happen. This prototype is a good start.

This version is only for display and is bonded to the production frame. It was printed using White Strong & Flexible material, painted and mounted on a wooden base.

Skull Wireframe Sculpture

a work that came from my first 3D short 'Man in Man'.

Skull Necklace 

The ISkull Vamp is an IPhone 'gramophone.' The eye sockets act as amplifiers to increase the sound from the phone's speaker. We modeled this skull hollow to save you money. The Regular non-Vamp iSkull is here: http://shpws.me/3Lvz