Replacement part for Fighter Variable Zero. Complete set of shoulder and elbow parts. Requirements minor disassembly. For right side.

Chip for the Sleeve to increase accuracy of the square malice pommel.

This set contains pieces for you to convert a 1/60 VF-0S or VF-0A into a VF-0C or VF-0D version. Paint required for completion.

Assembly most definitely required, as well as parts clean-up and sanding before applying paint.

All photos are straight-out-of-the-box polished WSF, minimal clean-up and trimming. Missiles not included.

MHS Igniter™ 18xxx disk Disk can be used to hold an Igniter™ board over an 18500 or 18650 stick pack. The disk fits inside standard MHS parts. It will not fit inside ribbed sections, chokes and some pommels. Purchase at least two (one for each end of the board).

A replica saber, this is the main body part of the "RK1". It's hollow all the way through for those wanting to install electronics. The control bar is secured onto the main body by use of gluing in the optional pins. The holes are set for thread tapping to fit 8mm screws.

There's also a hole that's goes all the way through where the box slides into to assist in those wanting to install electronics. A perfect location for a switch.

Please visit our website below to view how to construct your RK1 Saber:
http://polytrekindustries.blogspot.com/p/saber-industries.html