by
MarcoA
My case for Raspberry Pi computer. To be assembled with the "LED lightguide" model nr. 486757 (http://shpws.me/6yFP).
This is the case everyone is talking about! ;)
Features: snap-fit fixing system for the board, easy to mount/unmount; snap-fit closing system, no screw required; bottom holes for blocking the computer by screws (sliding mount); led lightguides (not included in this model, available here: http://shpws.me/6yFP ); pre-shaped hole for GPIO access, just cut it out to open.
In this page you can find a gallery of shots working cases by enthusiast users!
http://marcoalici.wordpress.com/raspberry-pi-case-gallery/
by
Dotsan
No1 in the series of animal heads, a smaller version of the 570mm high Stag Head (which is not available on Shapeways)
There is also a 75mm version here and a 300mm version here
The Animal Head Collection.
No 2 is a Zebra.
No 3 is a Rhino.
No 4 is a Tiger.
Tiger Head 2.
No 5 is an Elephant.
I'm experimenting with telling a story using minimal material to save on printing cost while inspiring the imagination.
Please send your pictures and share your thoughts on the design.
There is also a 75mm version here and a 300mm version here
The Animal Head Collection.
No 2 is a Zebra.
No 3 is a Rhino.
No 4 is a Tiger.
Tiger Head 2.
No 5 is an Elephant.
I'm experimenting with telling a story using minimal material to save on printing cost while inspiring the imagination.
Please send your pictures and share your thoughts on the design.
