The filigree design over the skull symbolizes ever growing renewal over the ghost of the past. This is the original design as featured on Kickstarter. It became their #1 most funded sculpture project of all time. Small is pictured sitting in the hand. See pic of all 3 sizes together for comparison.

The nocturnal (or nocturlabe) is a very old instrument for telling time at night by measuring the stars. While concept is ancient, this design is all original. It is fully functional (all dials move properly) and meant to be worn as a pendant. This is now available for sale, as it has been tested and works nicely.

How to Use the Nocturnal:

The top of the nocturnal is where you see a bit of a ring around a spike. This ring can be strung with a chain and makes it possible to wear the nocturnal as a pendant. When reading the nocturnal, this end of the piece should always be up.

Your first step is to set the outermost dial on the date. The months are shown as letters, with January and December at the top, and the progression of the months running *counterclockwise*. Note that the exact position of the letter actually marks the middle of that month. Look closer at the piece and you will see the line that separates the months between the letters.

Now, hold your nocturnal up to the starry night sky, making sure that the date is still properly set. Locate the North Star centred in the hole in the middle of the Nocturnal. Then use the central dial (the one that looks like a pointer) to point to the two stars at the end of the bowl of the *big* dipper.

Once you have this all set. Look closer at the pointer and you will see that within the pointer is an eliptical ring and within this is a smaller pointer. This smaller pointer points to a roman numeral, which shows you the time.

Note again, that the roman numeral is centred on the middle of the hour. So, if the little pointer points in the centre of the numeral, it is in fact half past.

So now you can tell time at night without a powered time piece. This is great for night owls, vampires, and those who appreciate a gothic or steampunk look.

The first public evolution of the Animaris Geneticus Parvus, #5. Featuring a fully working Theo Jansen mechanism as used in his work "the Rhinoceros". The mechanism is printed assembled, and will work without further assembly right after birth from the printer.
Also see our new Propeller Propulsion add-on, to have your Strandbeest walk autonomously!

A few tips to consider:

- After birth there might be a little powder left in some joints, or it might not go supersmooth. This will fix itself after the animal has a little bit of practice!

- Some surfaces work better than others. The legs require a little friction, and a flat surface. So for example: A rough table or floor, thin flat carpeting, or a thin rubber sheet. 

- The best way to push it is by its nameplate. Do not push down, but forward

The moon is now customizable. 1.5 inches wide. The placement and orientation of the loop can be set to your preference.

Bellyn the aries is a fellow of Reynard the Fox. He is often anxious but always clever. Bellyn is a character of an old kids tale.

Ring size is...
"Diameter 17 mm" - "US number size 6 3/4"

Please send me a message if you need other ring sizes!