by
roessnakhan
A replica of Cobb's totem from the film "Inception". As a below review has noted, and from my own version, the top works very well, and spins upwards of 90 seconds before toppling. You just might be in a dream.
by
joabaldwin
This is a mobius strip of Level 1 or Super Mario Bros. The whole level is wrapped around itself in a single surface, and poor Mario begins and ends at the same spot every time :(
All the elements from the level are there: every mushroom, turtle, cloud and star. They are all carved out of the surface at different heights, which looks fantastic when you have a light coming from the side, and each block casts a shadow.
It's a great piece to have on your desk, or to hang from a string to let it spin around.
All the elements from the level are there: every mushroom, turtle, cloud and star. They are all carved out of the surface at different heights, which looks fantastic when you have a light coming from the side, and each block casts a shadow.
It's a great piece to have on your desk, or to hang from a string to let it spin around.
by
virtox
Dodecahedral sibling of Gyro the Cube.
Same principle, more faces, more rings and more fun ;-)
Made of five nested dodecahedra, each one is limited to rotate about it's own axis.
This is the 6.5cm / 2.5" version, see the Gyro the Forms
Experimental corner stand available here
Instructions
For tighter clearances it is printed with the hinges out of place. So this model needs a little manual assembly. Each element has two "knobs" which need to be "clicked" into the corresponding "clamps" in the parent element.
It's easiest to start with the inner one and then continue outwards.
And then... rotate away !
Same principle, more faces, more rings and more fun ;-)
Made of five nested dodecahedra, each one is limited to rotate about it's own axis.
This is the 6.5cm / 2.5" version, see the Gyro the Forms
Experimental corner stand available here
Instructions
For tighter clearances it is printed with the hinges out of place. So this model needs a little manual assembly. Each element has two "knobs" which need to be "clicked" into the corresponding "clamps" in the parent element.
It's easiest to start with the inner one and then continue outwards.
And then... rotate away !
