You may have seen from yesterday's blogposts that we were honored to have Mayor Bloomberg cut the ribbon at the groundbreaking of the Shapeways Factory of the Future, with 3D Printed Scissors, of course.
We modified the design ever so slightly, introducing a slight curve in the blade to compensate for the 0.6mm gap that ensured the moving parts did not sinter together but there was still an easy shearing motion between the two blades. Then without further testing (yikes) we put the design on top of the build so that Mayor Bloomberg could take the scissors from the powder, clean them off and cut the ribbon.
Here you can see the progress with Mayor Bloomberg looking a little surprised that they worked perfectly straight out of the 3D Printer while Peter and Marleen look on relieved/joyous. It was a fantastic event and a massive thanks go out to Mayor Bloomberg and all elected official and press (including Betabeat and Gizmodo who gave the scissors some love) who attended along with the entire Shapeways team for making it happen, especially Carine and Elisa who spent HOURS in preparation....
I am so excited about the Factory of the Future! How long until its up and running like the other facility? Will all finishes be offered through this facility immediately? Will I be able to get my stainless steel prints here in the US now with faster turnarounds? So excited!!!! I will go investigate the forums for answers to these questions. Please email me with answers also.