Full Color Plastic 3D Prints from the Shapeways Community

The first wave of full color plastic 3D prints are starting to appear on the Shapeways forums showing the level of color saturation, material strength and precision that you can expect with your full color 3D prints.

3D printed full color plastic flowers Shapeways

Barratomica seems to have the best results so far with his full color plastic flower rings showing a nice color palette and regular, organic forms.

Others are having less success with their full color plastic 3D prints including our very own Mitchell with his scale model trains.  The colors in his model are not as crisp with a sligthly faded look to them as Multihawk also found with his prints.

As you can see below his full color plastic 3D prints look quite faded with some white spots evident on the surface and colors bleeding.  This may be in part because of the relatively small size of Multihak’s mini figurines, it would be interesting to see the exact same models in full color sandstone to compare.

Multihawk also experienced some warping in the thin areas of his small model as did Lensman with his Icicle and Stalactite Pendants Models where the small tips of the pendants were warped.  These models are also relatively small with a total length of around 5cm and just over 1cm at the widest point.  From this we may be able to deduct that the parts may go through some thermal shock after the printing process that is introducing this warpage.  As we learn more about this machine and the post processing we may be able to reduce this warpage that some designers are experiencing.

Thank you to all that are sharing their results in the It Arrived forum on Shapeways, we really appreciate your feedback as the more you tell us the more we learn.  Keep them coming.

3 comments

  1. KG

    Hi,

    We have this kind of printer at our office. Dip the parts in isopropanyl 99% alcohol to get better colors. It seems that the small powder particles are very static and tend to stick to the surface of the parts. The alochol rinse should help with this. The part will get a bit sticky from the alcohol but when dry it’s ok again.

Comments are closed.